In the insulating glass production line or improve the varieties of production, we will choose glass automatic shape cutting machine, but the following points at the time of purchase:

A cutting precision: used in the construction industry general requirements on the line in 0.5mm below; but for car mirror class in 0.01mm the following requirements. Now all the machinery manufacturers to provide cutting precision are generally in 0.2mm, but it can not look at the product specification is introduced, the acceptance shall have a complete set of test precision cutting process, we need to measure the actual cutting products accuracy prevail, we generally have more than a dozen test sample surface. Through the test we can fully grasp the synchronization control horizontal cutting platform and flatness control system.

Two. The cutting speed: in meet the premise of cutting precision can we talk about speed, because of the cutting platform is short, with the eyes is very difficult to judge whether the maximum speed, we can use the servo drive cutting machine with the software simulation function to check the motor speed is the highest. Don't cut in real test cutting speed, improve the acceleration and deceleration. Each axis can be tested separately, but also can be tested at the same time.

Three. Automatic typesetting optimization functions: in the cutting edge, taking into account the special processing cost and breaking work, generally will not arrange a high degree of people to do, this requires cutting machine operation to be simple, easy to understand, not too complex, otherwise it will create affordable machine can't afford machine an embarrassing situation. To have the best to avoid the defect function, because the plate glass made sometimes bad products. The heterotype cutting graphics library to multiple and flexible, should make CAD as graphics can also participate in the layout of.

Four. Easy maintenance: don't I/O signal and sensor on the machine equipped with too much, a switch and an indicator light is not necessary to be less as far as possible, because once a device failure will affect the use of mechanical cutting machine, few components failure probability is low, the wiring is small, easy to find fault and replacement parts, the best on the screen will be able to debug the I/O signal state. The maintenance cost is an important factor should be considered in the purchase of the machine on the.

Five. Save energy: in the same complete cutting size requirements, cutting the opportunity to choose the province energy consumption brought many benefits to enterprises. One is Protect environment, energy saving; two is to save the daily expenses of enterprises.